[time-nuts] Troubleshooting SR DG435 Four Channel Digital Delay/Pulse Gen
Brooke Clarke
brooke at pacific.net
Mon Jul 2 18:18:13 UTC 2007
Hi Bruce:
The common pin has a 100 ns period wave at + and - 500 mv.
One of the center pins on the INT/EX switch had + and - 1 volt at 100 ns period.
Have Fun,
Brooke Clarke
http://www.PRC68.com
http://www.precisionclock.com
Dr Bruce Griffiths wrote:
> Brooke Clarke wrote:
>
>>Hi:
>>
>>The DG535 Four Channel Digital Delay/Pulse Generator shows
>>Ext Clk Error on power up.
>>The obvious thing to do is turn the rear panel switch to INT, but after
>>powering up with the switch in either position the same error message appears.
>>
>>Connecting an external 10 MHz to the clock input and with the INT/EX switch in
>>either position the same error is there.
>>
>>The on line manual does not have schematics. Any thoughts?
>>
>>
>
> Brooke
>
> Is the longtailed pair Q502+ Q503 producing a 10MHz ECL level output signal?
>
> Bruce
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list