[time-nuts] Fury Interface Board: How about TI OPA277?
SAIDJACK at aol.com
SAIDJACK at aol.com
Sat Nov 3 18:47:38 UTC 2007
In a message dated 11/3/2007 02:19:49 Pacific Daylight Time,
bruce.griffiths at xtra.co.nz writes:
>Said
>Another consideration is that for 10544A's and similar oscillators which
>are only intended to drive high impedance loads( >= 1K) a simple 2
>transistor cascode buffer (or maybe a 10811A style common emitter stage
>with series feedback in the emitter circuit) may be required to allow
>them to drive a 50 ohm load or an RF transformer satisfactorily. A
>cascode buffer has higher isolation than a common emitter stage.
>Bruce
Hi Bruce,
that's a good point. The Fury can be turned into a high-impedance 10MHz
input by removing resistor R38.
This makes Fury also compatible with HCMOS OCXO's.
But removing this requires soldering, which unfortunately would void the
warranty..
bye,
Said
************************************** See what's new at http://www.aol.com
More information about the Time-nuts_lists.febo.com
mailing list