[time-nuts] Connector info for Trimble Thunderbolt GPSDO

[Jeff Walker]

I am looking for connector info (pin assignment and mating connector ID)
for a Trimble Thunderbolt receiver module. This is the OEM module
(probably telcom original customer) with just the receiver board contained
in the enclosure( no 24 volt DC-to-DC converter). Presumably the small
six (6) pin connector accepts +5, +12 and -12 volts DC. I need to know the
pin assignments of this connector and the ID of the mating connector, if 
possible.
The connector on the module is a "shrouded header" with a slot (in the 
shroud)
for polarization. The mating connector will have to be a 6 pin, female 
(socket)
configuration. The plastic housing would be approximately 3/32" wide by 0.6"
long. The size is similar to that for some of the connectors used for audio 
patch
connections on many PC soundcards. The header pins are round and smaller
than the standard 0.025 square header posts. Any info would be greatly 
appreciated.
73
Jeff Walker   W3JW