[time-nuts] Ovenaire OCXO pinout needed
dave powis
g4hup at btinternet.com
Sat Oct 6 22:56:12 UTC 2007
Hi John,
I don't have this particular OAM Unit - I have a model 42-23 - but I do have the pin-out for it, and it sounds very similar to what you describe, so maybe this will be helpful.
Viewed from above - ie as you would look down on it when on a board, with the pins to the left of the unit, they read from top to bottom as:
1 EFC IN - feedback from 10k trimpot for manual adjustment of Freq out
2 EFC REF - source voltage for 10k pot, hot end - cold end left open.
3 VCC +12v -heater supply?
4 GND
5 RF Out
6 VCC +10v - Osc supply?
I expect your unit uses the same arrangement, but at least this should give you something to experiment with.
73,
Dave, G4HUP / ND8P
----- Original Message ----
From: John Miles <jmiles at pop.net>
To: time-nuts at febo.com
Sent: Saturday, 6 October, 2007 9:42:27 PM
Subject: [time-nuts] Ovenaire OCXO pinout needed
Does anyone have access to the schematics for a Gigatronics 1026 signal
generator (50 MHz - 26.5 GHz)? If so, any chance you could look up the 10
MHz OCXO's pinout for me? I just picked up the OCXO from someone parting
out a 1026, but have no other information on it, and I'm guessing the only
hope for a pinout is to look in the original equipment's service manual.
This is a nice-looking Ovenaire unit, similar but not identical to the one
used in later-model Tek 49x spectrum analyzers. The model # is OSC 49-68.
There are six terminals coming out of it, but that's about all I can tell.
Thanks in advance for any info!
-- john, KE5FX
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list