[time-nuts] EFC Input pin impedance for the HP 10544A and 10811-6011
Mike Feher
mfeher at eozinc.com
Mon Oct 29 01:22:16 UTC 2007
According to the schematic in the 10811A manual, the EFC goes to a 100K ohm
resistor, then the varicap, and then the other side of the varicap through
another 100K ohm resistor to the reference of 6.4 volts. The manual does not
call out a DC input resistance, but, this should give you an idea. - Mike
Mike B. Feher, N4FS
89 Arnold Blvd.
Howell, NJ, 07731
732-886-5960
-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of xaos
Sent: Sunday, October 28, 2007 9:14 PM
To: Discussion of precise time and frequency measurement
Subject: [time-nuts] EFC Input pin impedance for the HP 10544A and
10811-6011
); SAEximRunCond expanded to false
Errors-To: time-nuts-bounces+mfeher=eozinc.com at febo.com RETRY
Hello everyone,
Does anyone know the input resistance of the EFC pin for the
HP 10544A and 10811-6011 OCXO's?
I have the spec sheet but it is not listed.
Can I assume something like 50K? This the the value for Crystek devices.
-George
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list