[time-nuts] Jupiter modules: 1pps or 10kHz to lock an OCXO ?
Didier
didier at cox.net
Mon Dec 22 00:02:40 UTC 2008
Patrick,
This has been covered extensively in recent past (this year). A quick look
through the archives will tell you more than you bargained for...
Didier
> -----Original Message-----
> From: time-nuts-bounces at febo.com
> [mailto:time-nuts-bounces at febo.com] On Behalf Of Patrick Reynaert
> Sent: Sunday, December 21, 2008 4:13 PM
> To: time-nuts
> Subject: [time-nuts] Jupiter modules: 1pps or 10kHz to lock an OCXO ?
>
> Hello,
>
>
> Using the 10kHz output to lock an OCXO is common practice and
> seems to give good results.
>
> Has anyone tried to use the 1pps output? One? could first
> make a simple divider to create a 0.5Hz reference with 50%
> duty cycle, and then use this signal to lock an OCXO. This
> would also allow the use of other OEM GPS modules that don't
> have the 10kHz but only the 1pps signal.
>
> Of course, as the 0.5Hz signal is much lower in frequency
> than 10kHz, the short-term stability is pushed more to the
> OCXO, making the requirements of the OCXO even harder.
>
> But maybe the 1pps signal has better stability than the 10kHz
> signal? Or is this the same since these signals will only
> influence the long-term stability of the oscillator and have
> the same accuracy?
>
> Any thoughts are highly appreciated.
>
> Thanks,
> Patrick.
>
>
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com To unsubscribe,
> go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list