[time-nuts] HP10811 problem - wrong frequency
Bruce Griffiths
bruce.griffiths at xtra.co.nz
Sun Jan 13 21:10:43 UTC 2008
John Miles wrote:
> Yes, I don't think a broken oven controller is going to pull the frequency
> off by 890 kHz. :-)
>
> -- john, KE5FX
>
If the oscillator is oscillating in an undesired mode, then it is likely
that the mode suppression network
(C5, C6 L2, L3 in the schematic) in the oscillator has a faulty
component or maybe a dry joint.
It probably worthwhile to check all the frequency determining components
in the oscillator at the same time.
You'll need to disassemble the oscillator to check.
Bruce
More information about the Time-nuts_lists.febo.com
mailing list