[time-nuts] LPRO 101 ADJUSTMENT
jshank
j-shank at comcast.net
Sat Jul 26 00:33:26 UTC 2008
If I choose to control the frequency via External C-field control I guess it
would take a very precise and stable voltage source. Any thoughts or
suggestions?
----- Original Message -----
From: "Scott Mace" <smace at intt.net>
To: "jshank" <j-shank at comcast.net>; "Discussion of precise time and
frequency measurement" <time-nuts at febo.com>
Sent: Friday, July 25, 2008 7:15 PM
Subject: Re: [time-nuts] LPRO 101 ADJUSTMENT
> Both methods work well. Be sure the unit is mounted to some sort of
> heatsink,chassis, etc.
> I'm using a Fury GPS receiver to drive the EFC on an LPRO-101.
> You won't get much range out of either adjustment. Leave it powered
> on for a couple of hours before trying to adjust it. I usually set the
> trim pot in the
> middle of it's range and use the EFC pin. I think it's a 28 or 30 turn
> pot. EFC
> is 0-5v. The unit will self-bias to around 2.5v if the EFC pin is open.
>
> Scott
>
> jshank wrote:
>> Hi,
>>
>> I recently acquired a LPRO 101 Rubidium Oscillator. After reading the
>> manual I see that there are two ways to adjust the frequency 1) using and
>> adjusting screw on the unit and 2) using the External C-field control
>> signal at pin J1-7. Has anyone experimented with either method and if so
>> what method was preferred?
>>
>> Jeff
>>
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
More information about the Time-nuts_lists.febo.com
mailing list