[time-nuts] The HP 10811-60111

[J. L. Trantham]

Roy,

I can't tell for sure from your comment if you need the manual for the 10811
but the manual for the 10811AB is available here:  http://www.hparchive.com/

I think you might already know of this site but just in case.

Joe

-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Roy Phillips
Sent: Wednesday, May 28, 2008 4:35 AM
To: Time Nuts
Subject: [time-nuts] The HP 10811-60111

Good members

I have a 10811-60111 Crystal Osc. which is attached (15 way edge connector),
to a PCB of Hewlett Packard manufacture. This later item has a type number
05328-20027 which suggests that it was part of the HP 5328 Counter. The PCB
is about half as big again as the XTAL Osc., and has 4 IC's, 3 transistors,
a "fine adjust" pot, and 2 adjustable C's (C12 & C15), and finally a 15 way
identical edge connector. Rick pointed me to the Agilent "old equipment"
site to download the 5328 Manual. This unfortunately does not have this unit
within, but shows a simple smaller interface. It is obviously a complete
control interface - ?oscillator and oven? . If anyone has the data on this
unit I would be most grateful for a copy, in particular the edge connector,
interconnections and set-up data.

Roy Phillips


_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.