[time-nuts] 10 MHz over optical fiber?

[Scott Mace]

I've used the ortel/emcore 5100 series for L-band IF links in places where the
distances and costs of running coax were too high.  Some of the products
launch hot as they were designed for passive/splitter based distribution
so you have to pad the optical rx.

	Scott

Lux, James P wrote:
> We do lots of this sort of thing at JPL. But the high precision does come at a cost..
> Here's a paper from Bob Tjoelker and colleagues..
> http://ipnpr.jpl.nasa.gov/progress_report/42-167/167C.pdf
> 
> There are various off the shelf products too, (you could buy a receiver and transmitter module from Ortel, for instance)
> 
> James Lux, P.E.
> Task Manager, SOMD Software Defined Radios
> Flight Communications Systems Section
> Jet Propulsion Laboratory
> 4800 Oak Grove Drive, Mail Stop 161-213
> Pasadena, CA, 91109
> +1(818)354-2075 phone
> +1(818)393-6875 fax
> 
>> -----Original Message-----
>> From: time-nuts-bounces at febo.com
>> [mailto:time-nuts-bounces at febo.com] On Behalf Of Scott Mace
>> Sent: Monday, November 24, 2008 8:37 AM
>> To: Discussion of precise time and frequency measurement
>> Subject: Re: [time-nuts] 10 MHz over optical fiber?
>>
>> I'm looking for the same thing, but between buildings over
>> singlemode fiber.  I have not evaluated any of these but I've
>> been looking at:
>>
>> http://www.terahertztechnologies.com
>> http://www.highlandtechnology.com/
>> http://www.luxlink.com/
>>
>>         Scott
>>
>> Marco IK1ODO -2 wrote:
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> 
>