[time-nuts] 10 MHz over optical fiber?
Didier
didier at cox.net
Wed Nov 26 02:48:07 UTC 2008
By the time you get the signal from the maser through 34 km of fiber optic,
what you get at the end might be not better than a decent GPSDO...
Make sure you go through your drift and jitter budget before commiting.
Didier
> -----Original Message-----
> From: time-nuts-bounces at febo.com
> [mailto:time-nuts-bounces at febo.com] On Behalf Of Scott Mace
> Sent: Tuesday, November 25, 2008 1:42 PM
> To: Discussion of precise time and frequency measurement
> Subject: Re: [time-nuts] 10 MHz over optical fiber?
>
> In looking at the off-the-shelf boxes, jitter seemed to vary
> from ps range to tens of ns. Also, how stable is the 34km of
> fiber... One of the manufacturers I looked at had a 1550nm
> option, so it's probably not a stretch to get it on a 100GHz
> ITU grid channel or other CWDM channel.
>
> Scott
>
> Paul Boven wrote:
> > Hi everyone,
> >
> > In message <20081124152247.DCDB0E91529 at mail.ebirds.it>,
> Marco IK1ODO
> > -2
> > writes:
> >> Hi all,
> >>
> >> I have to carry a 10 MHz standard frequency signal inside an EMC
> >> screened room via fiber optic cable.
> >>
> >> Not willing to re-invent the wheel, do something like an optical
> >> standard frequency link exist on the market?
> >> I think it is possible to use standard 100MB LAN transceivers, and
> >> POF. Phase noise requirements are not very stringent, and the
> >> distance is in the order of some tens of meters.
> >
> > I'm looking into something similar: transmitting an H-Maser signal
> > (probably 10MHz) over some 34km using CWDM SFPs. At first
> glance this
> > seems fairly uncomplicated: get some SFPs, and SFP
> connector + cage.
> > Use a fast opamp/differential driver to drive the transmitting SFP,
> > and use a similar setup at the other end to transform the received
> > data back to 50 ohm unbalanced. How feasible would such a setup be?
> > Possible problems might be that a 10MHz squarewave is
> simply too 'slow'
> > to be transmitted by an SFP, which expects 1.25Gb/s 8/10
> encoded data.
> > Another interesting question would be how much jitter/noise such a
> > setup would add?
> >
> > Regards, Paul Boven.
> >
> > _______________________________________________
> > time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to
> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> > and follow the instructions there.
> >
> >
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com To unsubscribe,
> go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list