[time-nuts] 5061A troubleshooting

[corby d dawson]

Scott,

I'm not sure how late a model you have but on the A15 board you should
see a place for two resistors that are connected on the board in
parallel.

If you connect a high resitance decade resistor (start at 10Megs) across
one of the resistors.

Now while monitoring the EM divided voltage reduce the decade resistor
until the EM test point increses to .25VDC.

Now solder  a 1% resistor of this value across the one of the other
existing resistors.

Now you are set up for 2500VDC EM voltage.


Corby Dawson
____________________________________________________________
Click here to become a professional counselor in less time than you think.
http://thirdpartyoffers.juno.com/TGL2141/fc/Ioyw6i3oJtoeZD8bdFl3HM6Qnrf4dkHES7UXgr2gqDl1I14G8tilHb/