[time-nuts] RF Mixers for oscillator comparison
Bruce Griffiths
bruce.griffiths at xtra.co.nz
Mon Apr 20 10:15:18 UTC 2009
GandalfG8 at aol.com wrote:
>
> In a message dated 20/04/2009 08:22:05 GMT Daylight Time,
> df6jb at ulrich-bangert.de writes:
>
> Minicircuits have a BROAD range of mixers. Among other they built the
> RAY-3,
> a 23 dBm high level mixer, that I have seen used in oscillator
> characterization publications. My understanding about the benefits of high
> level mixers for that purpose is that it allows you to work with higher RF
> levels which in turn leads to a higher IF level which in turn may lead to a
> better overall s/n of the system.
>
>
>
> ---------------
> An Ebay seller is offering some Stellex high level mixers, Item #
> 260382178618.
> I don't know if these would be of any interest in this application but
> perhaps worth taking a look.
> I bought a couple a while ago to try out in a radio front end but haven't
> had time to play with them yet.
> There's also a couple of links there to WJ and Minicircuits app notes on
> mixer usage and measurements.
>
> regards
>
> Nigel
> GM8PZR
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
Nigel
Those Stellex mixers definitely do have common RF, IF and LO grounds.
Either external RF transformers for the RF and LO ports would be
required to break low frequency ground loops or a low noise differential
input amplifier at the IF port (after the low pass filter) could be
useful in minimising mains related spurs.
The low phase noise isolation amplifier with +27dBm output required to
drive the LO ports would be interesting to design.
Bruce
More information about the Time-nuts_lists.febo.com
mailing list