[time-nuts] HP 105B Problem?
Greg Burnett
gbusg at comcast.net
Sun Aug 9 01:41:39 UTC 2009
Hi Ed,
IIRC it's normal for the circuit check meter readings to behave "squirrelly"
as you've described for the 3 output checks. I think this function is pretty
much only to "crudely" show that you have (or don't have) each output.
As for your 100kHz & 1MHz dropping-out when you load your 5MHz output into
25 ohms, this might be a sign of a marginal condition of your output
section - e.g., 5MHz signal dropping too low when loaded with 25 ohms?
However in practical use I think various destination instrument's timebase
inputs might require a bit more voltage than you'd have at best into 25 ohms
anyway. So I'd probably not load the 105B into such a low impedance.
Best,
Greg
More information about the Time-nuts_lists.febo.com
mailing list