[time-nuts] 10811 crystal orientation
Bob Camp
lists at cq.nu
Thu Jul 9 00:23:15 UTC 2009
Hi
I think that if you dig into it, you will find that there is a
polarized light process to orient the blank before the base plate is
applied.
Unfortunately for the discussion at hand, the direction of maximum G
sensitivity is still random relative to the mount.
Bob
KB8TQ
On Jul 8, 2009, at 7:06 PM, Rick Karlquist wrote:
> Remember that the SC cut is doubly rotated, so the crystallographic
> axes are tilted relative to plane of the blank. These angles are
> published in papers on the SC cut and controlled to extremely tight
> tolerances (a few seconds of arc). However, the 10811 crystal
> package is free to rotate to any random angle, so the
> crystallographic orientation of a 10811 crystal would only be
> consistent if the production line proactively installed them
> in a certain orientation. I don't remember ever hearing about
> anyone paying attention to how the crystals were oriented,
> in all my years of dealing with the 10811. If it were important,
> knowing how HP did things, the crystal package would be indexed
> so that the orientation would not be up to the whim of the
> assembler.
>
> Rick Karlquist N6RK
>
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list