[time-nuts] E1938 question

Dan Rae danrae at verizon.net
Thu Jun 11 13:26:44 EDT 2009

I have one of the "Chinese" E1938 modules I bought about a month ago.  I 
just tried it out on the bench, and have not had much luck with it.  The 
5 Volt supply never goes above 50 mA or so, none of the heaters seem to 
be powered looking at the "hockey puck" D-sub connector pins.  The four 
leds up by the PIC (?) seem to flash once on switch on and then pulse 
about once a second.  The other led which seems to be on the 5 V supply 
is on.  It does oscillate, but very low since it never warms up.

Is there any point in my trying to go any further with this?  It seems 
pretty dead to me, the PIC maybe?   :^(

Nice museum piece perhaps, but a bit expensive for only that...



More information about the time-nuts mailing list