[time-nuts] E1938 question
bruce.griffiths at xtra.co.nz
Thu Jun 11 19:56:07 EDT 2009
Dan Rae wrote:
> I have one of the "Chinese" E1938 modules I bought about a month ago.
> I just tried it out on the bench, and have not had much luck with it.
> The 5 Volt supply never goes above 50 mA or so, none of the heaters
> seem to be powered looking at the "hockey puck" D-sub connector pins.
> The four leds up by the PIC (?) seem to flash once on switch on and
> then pulse about once a second. The other led which seems to be on
> the 5 V supply is on. It does oscillate, but very low since it never
> warms up.
> Is there any point in my trying to go any further with this? It seems
> pretty dead to me, the PIC maybe? :^(
> Nice museum piece perhaps, but a bit expensive for only that...
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> and follow the instructions there.
You can also try pushing the PIC reset button near the front of the board.
More information about the time-nuts