[time-nuts] Vectron OXCO test.

brice at weaponeer.com brice at weaponeer.com
Tue Jun 16 22:18:14 EDT 2009


Thanks for the info Bob, It does work.

I just got my TM5006 travel test bench/ Tek TAS scope, Are we sure that is 12v?
I will check by case type but behaves as the voltage is possibly too high. 
Only 15.2 mA draw at 12.000v very clean waveform, good gain.
I have not modulated it yet. Working on stabilization. 
Maybe I am just being silly due to lack of sleep. 

Really cool toy, 100 mhz is correct, but pretty far off. I do not think it is a reject. but is possible. 

Thanks again.


E1 = +12VDC, 25 mA max
E2 = circuit ground
E3 = modulation input, 0-10VDC, .4kHz/V to 1.2kHz/V, negative transfer
E4 = case ground

100 MHz, +13 dBm output
40 ppm max, -18C to 75C
---------------------------------------------------------------------

On Mon, Jun 8, 2009 at 1:30 AM, <brice at weaponeer.com> wrote:
Vectron OXCO 233-5368-1 / WJ 708249-001

2.0" / 2.0" / 0.50"
SMA output / mil spec, Al sheet surface mount, 4 mounting studs

E1 orange / E2 black / E3 white / E4 (case ground)

Probably FSN 5955-01-144-2344

Alt part # may be V26G893 . May be 100MHZ
Can possibly get several more, new. Limited test equipment here, found conflicting data on part #'s.

All needed is voltages or pinouts. Sounds silly, do not want to guess.

Thanks, Bill

William Rice
Round Rock, Texas.




More information about the time-nuts mailing list