[time-nuts] GPS antenna installation problem
Stan W1LE
stanw1le at verizon.net
Mon Mar 2 01:56:17 UTC 2009
a couple of suggestions:
1. Use a captive center pin on the N male connector.
for example, Kings Electronics Inc. N male, model # KN-59-176 for RG-214
coaxial cable,
center pin is solder type and captive, will not move axially. Wrench
clamp on the shield.
Kings cage = 91836
mil spec: M39012/01-0005
a few bucks each
2. consider adding a foam in place insulation, inside the plastic pipe
to support the coaxial cable.
drill a 1/8" hole every few feet and squirt in the aerosol foam till it
comes out of the hole.
Go for the minimally expanding insulating foam you will find in Home
Depot or Lowes.
Stan, W1LE Fn41sr Cape Cod
Hal Murray wrote:
>> Two or one tee connectors will allow the cable to exit and reenter. If
>> your side arm is using a elbow now replace it with a tee.
>>
>
> Thanks, but I don't picture what you are trying to describe.
>
> Are you talking about tees and elbows in the pipe or cable?
>
>
More information about the Time-nuts_lists.febo.com
mailing list