[time-nuts] GPS antenna installation problem
sar10538 at gmail.com
Mon Mar 2 01:20:28 EST 2009
Gaffa tape the cable to the supporting pipe with a small drip loop
into the connector.
2009/3/2 Richard W. Solomon <w1ksz at earthlink.net>:
> One reason why I prefer crimp-on connectors.
> 73, Dick, W1KSZ
> -----Original Message-----
>>From: Stan W1LE <stanw1le at verizon.net>
>>Sent: Mar 1, 2009 8:56 PM
>>To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
>>Subject: Re: [time-nuts] GPS antenna installation problem
>>a couple of suggestions:
>>1. Use a captive center pin on the N male connector.
>>for example, Kings Electronics Inc. N male, model # KN-59-176 for RG-214
>>center pin is solder type and captive, will not move axially. Wrench
>>clamp on the shield.
>>Kings cage = 91836
>>mil spec: M39012/01-0005
>>a few bucks each
>>2. consider adding a foam in place insulation, inside the plastic pipe
>>to support the coaxial cable.
>>drill a 1/8" hole every few feet and squirt in the aerosol foam till it
>>comes out of the hole.
>>Go for the minimally expanding insulating foam you will find in Home
>>Depot or Lowes.
>>Stan, W1LE Fn41sr Cape Cod
>>Hal Murray wrote:
>>>> Two or one tee connectors will allow the cable to exit and reenter. If
>>>> your side arm is using a elbow now replace it with a tee.
>>> Thanks, but I don't picture what you are trying to describe.
>>> Are you talking about tees and elbows in the pipe or cable?
>>time-nuts mailing list -- time-nuts at febo.com
>>To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>>and follow the instructions there.
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
Steve Rooke - ZL3TUV & G8KVD & JAKDTTNW
Omnium finis imminet
More information about the time-nuts