[time-nuts] About HP10544A
J. L. Trantham
jltran at worldnet.att.net
Tue Mar 10 01:08:43 UTC 2009
Esa,
I am back home now and can't access the amigazone files from my home IP.
Can you provide access?
Thanks,
Joe
-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Esa Heikkinen
Sent: Monday, March 09, 2009 4:51 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] About HP10544A
> Since retrofitting an improved oscillator circuit isn't really an option
> you will need to filter the output to reduce the harmonic content.
> Try a bandpass filter driven by the buffer and terminated in 50 ohms.
Well I have to decide what to do, get another oscillator or try the
filtering. The difference to another oscillators (like tbolt ocxo or
LPRO) is so huge that I do not know how hard it would filter the 10544A
to the same level, which parts to use and how much it will cost.
> Should you retrofit an improved oscillator circuit you may as well
> replace the oven controller to eliminate the oven switching frequency
> related sidebands.
Infact the switcher sidebands are now gone:
http://www.amigazone.fi/files/gpsdo/544-13.png
http://www.amigazone.fi/files/gpsdo/544-14.png
It was like thios earlier:
http://www.amigazone.fi/files/gpsdo/544-1.PNG
http://www.amigazone.fi/files/gpsdo/544-2.PNG
It was easier than I expected... When I took the output directly from
OSC pins without using the coax connector like you suggested the
switcher peaks was gone!
So I had a closer look to the PCB today and noticed that it has only 2
layers and the ground net is too thin and goes around PCB totally wrong
way so that switcher current seems to flow via the signal flow. It's PCB
layout design fault, I think that with correct layout design this could
be done even with 2-layer PCB correctly.
But this is not a problem of course because I will design my own PCB for
the final system anyway, having SMA connectors for 10 MHz and EFC. I'll
also create separate power supply for ovens and signalling stages.
--
73s!
Esa
OH4KJU
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list