[time-nuts] HP 8660C-K10 phase modulation test set
John Allen
john at pcsupportsolutions.com
Sun Sep 20 22:13:56 UTC 2009
More information -
>From
http://ko4bb.com/Manuals/HP_Agilent/HP_-_8660_Synthesized_Signal_Generator/HP_86602B_MIL_Maintenance_Manua.pdf
Page 4-45:
DESCRIPTION:
The phase modulated output of the System Under Test is demodulated using a
phase modulation test set. The harmonic levels are measured with a spectrum
analyzer and the total harmonic distortion is calculated. A low pass filter
is used between test oscillator and modulation section to insure that the
modulation drive signal has less than 0.3% distortion.
John, K1AE
----- Original Message -----
From: "Mark Kahrs" <mark.kahrs at gmail.com>
To: "Discussion of precise time and frequency measurement"
<time-nuts at febo.com>
Sent: Sunday, September 20, 2009 12:26 PM
Subject: [time-nuts] HP 8660C-K10 phase modulation test set
> Among my mistaken acquisitions over the past is a phase modulation
> test set for the 8660C (model 8660C-K10).
>
> I've put two pictures here:
>
> http://www.caip.rutgers.edu/~kahrs/ebay/8660C-K.1.JPG
> http://www.caip.rutgers.edu/~kahrs/ebay/8660C-K.2.JPG
>
> This looks like a type of phase noise test set: there is a LO in a
> sealed box in one corner. There are mixers and detectors and a
> divider board.
>
> I thought I would see if there was any interest from time-nuts before
> I put it on the usual auction site.
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list