[time-nuts] Stuck Z3801A
Hal Murray
hmurray at megapathdsl.net
Thu Sep 24 05:08:53 UTC 2009
My Z3801A lost contact with the GPS world: no satellites. It was in holdover
for several days before I investigated. I poked around but didn't find
anything. It recovered after I cycled power.
Has anybody seen anything like this? Or know what's going on? What should I
look for if it happens again?
It's been running over 5 years. My antenna is in a poor position so my setup
is good at tickling a large set of weird bugs. I may have seen something
like this before but I'm not sure.
Here is a status page before power cycling:
SYNCHRONIZATION ............................ [ Outputs Valid/Reduced Accuracy
]
SmartClock Mode ___________________________ Reference Outputs
_______________
Locked to TFOM 5 FFOM
2 Recovery 1PPS TI -110.7043 us rel to
GPS
>> Holdover: GPS 1PPS CLK invalid HOLD THR 1.000 us
Power-up Holdover Uncertainty
____________
Predict 11.6 us/initial 24 hrs
Holdover Duration: 28h 22m Present 16.2 us
ACQUISITION .......................................... [ GPS 1PPS CLK Invalid
]
Satellite Status __________________________ Time
____________________________
Tracking: 0 Not Tracking: 8 UTC 21:31:48 23 Sep
2009
PRN El Az PRN El Az 1PPS CLK Invalid: not tracking
* 2 29 177 *27 62 284 ANT DLY 10 ns
* 4 48 144 *28 23 92 Position
________________________
* 9 54 299 MODE Hold
12 22 297
15 12 224 LAT N 37:26:05.188
*17 47 44 LON W 122:12:16.074
ELEV MASK 10 deg *attempting to track HGT +45.89 m
(MSL)
HEALTH MONITOR ......................................................... [ OK
]
Self Test: OK Int Pwr: OK Oven Pwr: OK OCXO: OK EFC: OK GPS Rcv: OK
--
These are my opinions, not necessarily my employer's. I hate spam.
More information about the Time-nuts_lists.febo.com
mailing list