[time-nuts] Naval Jelly at home depot 25-35% Phosphoric acid

Bill phase3 at wcc.net
Sat Apr 10 18:44:42 EDT 2010

I keep at least a couple of gallons of phosphoric acid on hands at all
time....I have some brass antenna feed through insulator rods cleaning as of
this minute.  It also will clean all mineral deposits from your sink,
toilet, etc.  It prepares some hard to solder surfaces (like nichrome) for
easy application of rosin core solder.

Bill Mason

-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of paul swed
Sent: Saturday, April 10, 2010 1:12 PM
To: Time-nuts
Subject: [time-nuts] Naval Jelly at home depot 25-35% Phosphoric acid

A bit back there was quite a discussion on soldering nichrome wire and other
Phosphoric acid seemed to be the key.
Finally was able to stop in at home depot and 8oz cost $3.99. Its in the
paint section called naval jelly from loctite.
As so many commented in the thread. Fun to watch the clerks response to even
naval jelly. Dohhh is the best description.
I looked at the grout haze remover and that was actually sulphuric acid.

Looking up the naval jelly msds its 60% water 25-35% Phosphoric acid and
some other stuff. Generally nasty.
Now to find some scrap steel and nichrome wire and try to solder to it. In
an open air place.
Thanks everyone for the clue. Thats whats good about time-nuts.
By the way 8 oz would dry up before you ever use 1-2 oz of the stuff I would
guess. But thats as small as it comes.
Thanks again
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
and follow the instructions there.

More information about the time-nuts mailing list