[time-nuts] What's the latest correct PICTIC II Mouser project?

Steve Rooke sar10538 at gmail.com
Fri Aug 6 23:16:55 UTC 2010


Bob,

Thanks for that, this Mouser project has all available parts. Do you
know if the pots, trimmers, etc. are ones as suggested for the correct
orientation, pin spacing, etc. as i believe there was some discussion
regarding this in among the many postings on this topic?

Steve

On 07/08/2010, Bob Camp <lists at rtty.us> wrote:
> Hi
>
> I believe the project at:
>
> http://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=8736DCEE10
>
> is up to date in (no un-orderable parts).
>
> Bob
>
> -----Original Message-----
> From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
> Behalf Of Didier Juges
> Sent: Friday, August 06, 2010 8:36 AM
> To: 'Discussion of precise time and frequency measurement'
> Subject: Re: [time-nuts] What's the latest correct PICTIC II Mouser project?
>
>
> I have not seen an answer to that question (for people in the US) ?
>
> I am waiting for the PWB, which I believe I paid for, and I am planning to
> buy or make (have not looked into that yet) a PIC programmer, since it looks
> like I may get some mileage out of that anyhow.
>
> No rush, but there is no good reason to delay either at that point.
>
> Thanks
>
> Didier
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>


-- 
Steve Rooke - ZL3TUV & G8KVD
The only reason for time is so that everything doesn't happen at once.
- Einstein




More information about the Time-nuts_lists.febo.com mailing list