[time-nuts] PicTic Data
Stanley Reynolds
stanley_reynolds at yahoo.com
Sun Aug 15 02:55:07 UTC 2010
One problem is the door opens don't move in the same direction, a rain storm did
cool things off outside during the test but it was still warmer outside both
times.
I will place a box over the Pictic and rerun the test.
Stanley
----- Original Message ----
From: Stanley Reynolds <stanley_reynolds at yahoo.com>
To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
Sent: Sat, August 14, 2010 9:38:37 PM
Subject: Re: [time-nuts] PicTic Data
No, the board is not in a case. An annotated graph attached. I think the 100 sec
oscillations are a vane that moves up and down on the a/c unit as this is washed
out on the two door opens.
----- Original Message ----
From: Bob Camp <lists at rtty.us>
To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
Sent: Sat, August 14, 2010 9:18:44 PM
Subject: Re: [time-nuts] PicTic Data
Hi
Is it shielded from drafts?
Bob
On Aug 14, 2010, at 10:12 PM, Stanley Reynolds <stanley_reynolds at yahoo.com>
wrote:
>
>
> My guess as to what the data may indicate is performance of the 10 Mhz 20PPM
> PICTIC internal oscillator, need to repeat test with precision 10Mhz and auto
> calibrate off. Fatness of the line/width maybe PICTIC error. Note graph seems
>to
>
> show me leaving the room and returning via the outside door. Not sure what the
> ~100 sec oscillations are, need to check a/c cycle time.
>
> Stanley
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list