[time-nuts] Different Survey Results
WarrenS
warrensjmail-one at yahoo.com
Thu Aug 19 19:32:02 UTC 2010
Peter asked:
>2) Is it necessary to modify Tbolt settings or does tbold work best with
>factory settings?
The answer is, for best performance you need to modify the factory setting.
There has been much posted on which ones and how, but bottom line is it all
depend on what your setup is and what you want it to do.
It is a tradeoff to reduce the GPS short term noise and correct for the
oscillator's long term noise.
The best settings depend on what the noise frequencies and amplitude are in
the two items and that depends on many things.
The default setting for the Tbolt are meant to be used with a very GOOD
antenna system and a not so good OCXO in a POOR environment.
My situation is just the reverse. In one of my Tbolt units I'm using a very
good OSC in a controlled constant temperature environment with a poor indoor
antenna. The Default setting in this case are a disaster from a best
performance standpoint.
What I have found to give good general results if you do not want to fine
tune your specific Tbolt unit and
assuming a typical nut setup in a good environment (which includes adding
some thermo mass to the Tbolt),
1) change the TC to 300,
2) the damping to 0.7
3) the Dac gain to -3.0 Hz/V,
4) the Elevation to 20 deg,
5) the AMU to 3.0
6) and then do a 24 or 48 hr survey if you are using Lady Heather
or change the default survey size from 2,000 samples to more like 20,000+
samples, to a value that averages over at least 12 hrs, and have it save the
location.
ws
*******************
[time-nuts] Different Survey Results
Peter Krengel krengeldatec at gmx.de
Thu Aug 19 16:28:52 UTC 2010
Hello,
I'm new to the list and to the themes at all. I'm running a V3 Thunderbolt
using the great Lady Heather Software (thanks for this).
Setting up the tbold for the first time I made a 48h survey.
To compare the results I also started a SirF III GPS using VisualGPS
software and after the 48h period I got totally different results.
Knowing my real geografic coordinates very well I saw that the tbold
obviously calculated wrong data.
So my questions to the group are:
1. For getting best disciplining results out of the tbold: Do I better
put in the coordinates manualy or using the survey function?
2. Is it necessary to modify DAC and temperature settings using
command line options (or using the heather) or does tbold work best with
factory settings?
3. Is there any "How to.." pdf or book on the net which comes with more
informations about the tbold experiences than the well known
official pdf from 2003 ?
Thank you very much for help.
73 from germany
Peter Krengel
DG4EK
More information about the Time-nuts_lists.febo.com
mailing list