[time-nuts] Phase noise measurement (was - no subject)
EWKehren at aol.com
EWKehren at aol.com
Sat Aug 21 16:33:06 UTC 2010
Thanks Bert
In a message dated 8/21/2010 11:43:53 A.M. Eastern Daylight Time,
dk4xp at arcor.de writes:
> Wenzel Audio Amp referred to in this email. Perfect! I drive with it a
> 3561A and a 7L5! Works for me. The only problem is getting any more
> 2SK369.
> Any recommendations?
NXP BF862, available from digi-key.
I have used it in a similar hookup with good success. Its virtue is the
low noise voltage AND low input capacitance at the same time.
You could deploy MANY of them in parallel until you get
into the capacitance range of a single Interfet device.
One heroic effort for audio is here:
http://www.diy-audio-engineering.org/index.php?board=2.0 HPS5.1
I currently use 3 pairs of SSM2210 in front of a AD797.
regards, Gerhard
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list