[time-nuts] Systron Donner 100A pulse generator
Rob Kimberley
rk at timing-consultants.com
Sat Dec 11 20:24:53 UTC 2010
I used to build and test these in the early 70's when I worked for
Systron-Donner Limited, in Leamington Spa, UK. We were the UK subsidiary.
They also had similar facilities in Paris and Munich.
Good old days!!
Rob Kimberley
-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of EB4APL
Sent: 11 December 2010 3:45 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Systron Donner 100A pulse generator
Alf,
Some time ago I scanned my copy and uploaded to a couple of sites being
Didier's
http://www.ko4bb.com/Manuals/09%29_Misc_Test_Equipment/Systron_Donner_100A_P
ulse_Generator_Service_Manual.pdf
one of them.
I can send you directly a later revision (of my pdf edition with correct
page numbering, not a manual revision). It is about 2.8 Mb.
Regards,
Ignacio
EB4APL
El 11/12/2010 16:02, Alf Pousar escribió:
> Hi,
> can any of you help me, I need a manual with schematic or just the
schematic for this device.
> The timing is done with a tunnel diode, and to be able to repaire the unit
a schematic would help a lot!
>
> Please help, if you can.
>
> Alf Pousar
> OH2QM
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list