[time-nuts] Frequency comparison
Raj
vu2zap at gmail.com
Tue Feb 9 07:05:15 UTC 2010
Bob,
You are right, I am using an analog multi-meter where its easy to observe the
needle movement.
At 08-02-10, you wrote:
>Hi
>
>If you mix the RB and GPS down with a mixer you eventually will run into a
>problem.
>
>As you set them both very close to frequency, the output is a noisy DC
>signal rather than a sine wave. Since each source can drift either up or
>down for a short period of time, it can be hard to tell what's going on with
>a zero crossing detector. It is much better to capture the output voltage
>with a strip chart or the digital equivalent.
>
>Bob
--
Raj, VU2ZAP
Bangalore, India.
More information about the Time-nuts_lists.febo.com
mailing list