[time-nuts] Advice on 10 MHz isolation/distribution (Clay)
life speed
life_speed at yahoo.com
Sat Feb 20 19:46:14 UTC 2010
From: Pete Rawson <peterawson at earthlink.net>
Subject: Re: [time-nuts] Advice on 10 MHz isolation/distribution
To: Discussion of precise time and frequency measurement
<time-nuts at febo.com>
Message-ID: <1027D446-FE23-45A7-88AD-1CFD339C4ABB at earthlink.net>
Content-Type: text/plain; charset=us-ascii
Clay,
I would really like to have a copy of your test board for this effort.
I'm sure it will be a challenging layout. But it could be a very handy
piece of hardware. Supporting a PCA order would easy to do.
Pete Rawson
I always buy more than one PCB, 5 - 6 don't cost any more than 1. Unfortunately, I don't think my favorite prototype shop (PCB123) will be suitable for a layout with voids in the ground plane (reduce parasitic C) under the opamp and R4003C on the top layer, so I will have to do a 'real' PCB. I was also planning on using the leadless version of the part, which could be challenging for home assembly.
Everything is leadless these days. Gives me fits sometimes. I just went through a nightmarish experience with a leadless ARM7 processor that needed some wires added. I replaced it with a leaded part at a cost of 2 mm PCB area . . . but I digress.
Clay
More information about the Time-nuts_lists.febo.com
mailing list