[time-nuts] Fw: Low noise voltage regulators

[Stanley Reynolds]

Sorry file ext was upper case, fixed now ... also the source label "HP 10811A/B ..." moved to the bottom of post, I was trying to attach the picture but it bounced as too big.

Stanley



----- Original Message ----
From: Brian Kirby <kilodelta4foxmike at gmail.com>
To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
Sent: Thu, February 25, 2010 1:15:11 PM
Subject: Re: [time-nuts] Fw: Low noise voltage regulators

Stanley Reynolds wrote:
> 
> 
>  


Sorry, the page you requested was not found


> ----- Forwarded Message ----
> From: Stanley Reynolds <stanley_reynolds at yahoo.com>
> To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
> Sent: Thu, February 25, 2010 1:00:58 PM
> Subject: Re: [time-nuts] Low noise voltage regulators
> 
> >From the : "2-11. A single source of +20 to +30V dc with 10% regulation may be used to power both the oven and
> oscillator amplifier circuits if a simple IC regulator is used. A suggested circuit is shown in Figure
> 2-1. The resistor and capacitor connected to terminals 3 and 4 of the IC minimize ripple and noise
> in the regulated output."
> 
> www.n4iqt.com/hp/12volt-reg.jpg
>  I have planed to separate the power supplies from my test stands as my next project for the 10811's so I'm also interested in a suitable supply.  Considered a battery supply with a regulator for the 12 V side.
>  Stanley
>  10811A/B Quartz Crystal Oscillator Operating &
> Service Manual (V2)
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> 
>  


_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.