[time-nuts] thunderbolts not seeing satellites
James R. Gorr
n3toy at yahoo.com
Sun Jan 3 20:13:32 UTC 2010
Hello everyone! Hope your new year is going well so far.
I have two Tbolts (one from TAPR and one from another guy), and neither one is locking on satellites.
My set up is a Lucent antenna, about 12 feet of LMR400, a Symmetricom 4 way Active "SmartSplitter", then about 3 feet of LMR 195 to my non-TAPR Tbolt. I have another GPS (non Tbolt) on the SmartSplitter also (that works fine, ie: is RX satellites). This set up has worked for a couple years.
I originally powered my non-TAPR Tbolt with three "wall warts". When I got this GPS, I was told it took non-standard power of +12/+5/-7.
A while ago I noticed my Tbolt stopped working. I took it offline and replaced it with one I bought from TAPR a year previous. Additionally, I powered my "new" Tbolt with an HP 6236B, and everything worked fine.
Now, this morning I noticed my Tbolt is not working again!
It powers up, draws expected current on start up (then backs down after oven warms up) and I can monitor it with tboltmon.exe.
I did a factory reset then manually input my position.
No critical alarms are showing (all green) and minor alarms are all green except for: Satellite Tracking, Oscillator Disciplining, and Almanac, which are yellow.
I have all 0.0 AMUs under Signal Levels.
I think because the other GPS (non-Tbolt) works, my antenna and splitter is fine.
I have also tried switching ports on the splitter.
I have tested my jumper cable for shorts and continuity.
Interestingly enough, if I power my original Tbolt (the +12/+5/-7 one) from the wall warts, it will "see" 2 satellites, but with very poor signal strength. It will not see anything powered with +12/+5/-12 from the HP PS.
Both Tbolts have the same symptoms.
Anyone ever see issues like this? Or have any suggestions?
Jamie
More information about the Time-nuts_lists.febo.com
mailing list