[time-nuts] DMTD Question
EWKehren at aol.com
EWKehren at aol.com
Mon Jan 25 17:46:42 UTC 2010
Before any body gets upset, I said before I used the wrong price
calculator. The present mixer/counter takes up 4.3 by 5.3 inches, can be separated
into two boards and in 100 qty would be $ 9.60 with silk screen and solder
mask. Bert Kehren
In a message dated 1/25/2010 12:10:43 P.M. Eastern Standard Time,
james.p.lux at jpl.nasa.gov writes:
> -----Original Message-----
> From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Mark Sims
> Sent: Monday, January 25, 2010 8:53 AM
> To: time-nuts at febo.com
> Subject: [time-nuts] DMTD Question
>
>
>
> Your board costs are WAY out of line... Are the boards 2 layer or 4
layer?
>
> You can get 2000 square inches of 2 layer boards for 12 cents/sq in +
$120 setup. 4 layers are around
> 20 cents/sq in + $320 setup. See mylydia.com
>
> I would layout the two boards side by side and connected like they would
normally be used. If you
> don't want to use the counter, saw it off. This would save two setup
charges. So for 2 layer your
> cost is under $4.50 a set and under $10 for four layers. 2000 sq inches
gives over 80 sets of boards.
>
Does mylydia cost include sawing the 80 sets out of the 2000 square
inches? (their website doesn't say)
I think the cost that was previously cited includes all the parts on the
board. And might include a variety of manufacturing incidentals that all
add up, too. Some board houses automatically do the post mfr continuity
tests, for instance.
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list