[time-nuts] Magnavox GPS engine

[bg at lysator.liu.se]

Hi Bob,

Is this the ca 1991 GPS Engine by Magnavox?  (board size approx 65 x 165 mm)

There is some documentation available in this thesis:

     http://www.physics.adelaide.edu.au/~cwilkins/thesis.tar.gz

--

    Björn

> Unfortunately not. This is more of a Jupiter looking module with the
> classic 20 pin DIL header.
>
> Thanks tough!
>
> On Thu, Jul 22, 2010 at 1:22 PM, Brooke Clarke <brooke at pacific.net> wrote:
>> Hi Bob:
>>
>> Like this:
>> http://www.prc68.com/I/MX4102.shtml#4200
>>
>> Have Fun,
>>
>> Brooke Clarke
>> http://www.PRC68.com
>>
>>
>> Bob Bownes wrote:
>>>
>>> Does anyone have any documentation on these GPS modules? I've been
>>> unable to determine anything other than Magnavox sold the line to
>>> Leica.
>>>
>>> They have a 20 pin header much like a Jupiter, but don't appear to be
>>> pin compatible.
>>>
>>> Thanks,
>>> Bob
>>>
>>> _______________________________________________
>>> time-nuts mailing list -- time-nuts at febo.com
>>> To unsubscribe, go to
>>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>>> and follow the instructions there.
>>>
>>>
>>>
>>
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>