[time-nuts] Thunderbolt not seeing satellites

GandalfG8 at aol.com GandalfG8 at aol.com
Thu Jun 10 18:43:46 EDT 2010


In a message dated 10/06/2010 23:34:05 GMT Daylight Time,  
holrum at hotmail.com writes:

I'm not sure of the required power spec,   but 28V may be too low.  These 
were meant to run off a telco power bus  (nominal 48V).  
I run mine at 40V (from a Tek PS503A mounted in a TM501  mainframe,  unit 
connected across the + and - supply terminals,   outputs set to +/- 20V).  It 
won't run at  28V.

-----------------
One needs to be careful as there may be  different versions, checking is 
certainly to be recommended but this  comment comes from versions 3, 4, and 5, 
of the Thunderbolt  manual.....

The ThunderBolt comes with a 24V power supply regulator. A  locally 
supplied +24VDC
is required. Power consumption is 15 watts cold and  10 watts steady state. 
The connector
is an AMP mate-n-loc (AMP part number  643228-1). The AMP mate-n-loc mating
connectors are listed in the table  below. An AMP hand tool (PN 90300-2) 
may be required......
 
regards
 
Nigel
GM8PZR
 




More information about the time-nuts mailing list