[time-nuts] schematics for a HP117a please
paul swed
paulswedb at gmail.com
Sat May 1 15:31:08 UTC 2010
Thank you for the replies and help.
Regards
On Sat, May 1, 2010 at 6:20 AM, <GandalfG8 at aol.com> wrote:
>
> PS
>
> The antenna schematics and photos are on TVB's site as Dan suggested....
>
> _http://www.leapsecond.com/museum/10509a/_
> (http://www.leapsecond.com/museum/10509a/)
>
> These are much better quality than those in the HP manual so well worth
> getting both.
>
> regards
>
> Nigel
> GM8PZR
>
> In a message dated 01/05/2010 11:11:25 GMT Daylight Time,
> GandalfG8 at aol.com
> writes:
>
> Paul, to get these to work, you will need the loop antenna. This has,
> in the early versions at least, a Nuvistor amplifier in it with a
> crystal filter built in to it. I think there was a later version that
> had transistors. I have seen the schematic somewhere, have you tried
> TvB's site?
>
> Hi Dan and Paul
>
> The ops and service manual is available from the Agilent site........
>
> _http://cp.literature.agilent.com/litweb/pdf/00117-9029.pdf_
> (http://cp.literature.agilent.com/litweb/pdf/00117-9029.pdf)
>
> Although not the best pdf manual ever it does contain the schematics,
> including both antennas, and should be usable.
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list