[time-nuts] Best way to...?

Robert Darlington rdarlington at gmail.com
Wed Dec 14 20:14:09 EST 2011


I didn't feel like digging for an allen key so I just drilled from the back
side of the board.  I didn't go all the way through.  It was just enough to
remove the nut or anchor that was attached to the PCB.   It took about 1
minute.

-Bob

On Wed, Dec 14, 2011 at 2:48 PM, Don Latham <djl at montana.com> wrote:

> I just checked: it's a 1/16 in. hex wrench ( not metric.) They've been
> driven in hard, don't give up...
> Don
>
> GandalfG8 at aol.com
> > In a message dated 14/12/2011 21:41:13 GMT Standard Time,
> > kyrrin at bluefeathertech.com writes:
> >
> > What's the best way folks have found to remove the Ebay special  5680's
> > from the hunk of PC board they're rivited to on  arrival?
> > Alan/Hex key, what look like rivets are screws  :-)
> > _______________________________________________
> > time-nuts mailing list -- time-nuts at febo.com
> > To unsubscribe, go to
> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> > and follow the instructions there.
> >
>
>
> --
> "Neither the voice of authority nor the weight of reason and argument
> are as significant as experiment, for thence comes quiet to the mind."
> R. Bacon
> "If you don't know what it is, don't poke it."
> Ghost in the Shell
>
>
> Dr. Don Latham AJ7LL
> Six Mile Systems LLP
> 17850 Six Mile Road
> POB 134
> Huson, MT, 59846
> VOX 406-626-4304
> www.lightningforensics.com
> www.sixmilesystems.com
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>



More information about the time-nuts mailing list