[time-nuts] SRS PRS10 problem

[Brendan Minish]

Thank so much for taking the time to do this, it's genuinely much 
appreciated

My replacement fet for the lamp assembly is on it's way from China and 
I'll report back how I get on with the repair

73
Brendan

My

On 23/02/2011 15:29, Robert Watson wrote:
> OK, Here is the result of my lunch-break scanning session. I had to
> use a desktop A4 sized scanner so you might need scissors and tape to
> make sense. The 17x11 sheets are split onto overlapping two letter
> sized pages (Rb lamp driver is on last couple of pages). Don't have
> time to tidy it at this stage.
>
> Usual caveats: link may not be around forever so if someone wants to
> find a better home for it, do so. For personal use only etc.
> http://people.bath.ac.uk/eesrjw/prs10/PRS10_revH_BoM_schematics.pdf
>
> Regards,
> R.
>
> On 23 February 2011 09:04, Robert Watson
> <robertwatsonbath at googlemail.com>  wrote:
>> Hi folks,
>>
>> OK, have found the manual and it's not as bad as I remembered; there
>> are six 17"x11" fold out sheets. The schematics are dated August 12th
>> 1999 and are for "Revsion H". I'll scan the schematics and the parts
>> list in case that helps folks with non rev. H units. There are no
>> copies of the silkscreens for component ident as near as I can see.
>> Will see if I can scan these in the next couple of days.
>>
>> R.
>>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.


-- 
73
Brendan EI6IZ