[time-nuts] FE5860A CONNECTIONS
Ed Palmer
ed_palmer at sasktel.net
Tue Mar 15 05:14:22 UTC 2011
Dan,
Those aren't rivets holding the unit to the circuit board. They're
1/16" hex screws. Just unscrew them. Much easier than drilling them
out. :-)
Ed
Dan Rae wrote:
> On 3/14/2011 7:27 PM, Murray Greenman wrote:
>> Dan,
>> Yes, you are right. There are so many variants of the FE-56xx devices
>> that I'm sure even FEI don't have a clue which is which!
> Thanks Murray and Rex. I'll drill out all the rivets and open it up
> tomorrow and have a look inside to try and figure out what's actually
> needed for this particular version. All the eBay sellers seem to
> agree that it needs 5 as well as 15 Volts, it's just on which pin is
> the question.
>
> If I find anything of interest, I'll report further.
>
> Dan
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list