[time-nuts] Parts Selection

[Bob Camp]

Hi

The "would you buy one?" question is this:

Some (like me) buy things and then put them on the shelf hoping for
"inspiration" (or desperation) to strike. The more complex the assembly, the
less likely they are to complete. Others simply are not willing to spend
over say $100 on any sort of kit.

Bob


-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Javier Herrero
Sent: Friday, March 25, 2011 1:29 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Parts Selection

Hi

>
>
> Done it in the before - yes.
>
>
>
> Done it in the basement / last 2 years - and from quite longer than
that...
>
>
>
> Set up to do it in the basement - yes
>
>
>
> Would I buy one - I'm afraid I don't fully understand your question, but I
routinely buy and solder 0.5mm spacing TQFPs (counts as yes?)
>
>
> Would actually do it in a reasonable amount of time - define reasonable :)
but yes, quite fast...
>

-- 
------------------------------------------------------------------------
Javier Herrero                            EMAIL: jherrero at hvsistemas.com
Chief Technology Officer
HV Sistemas S.L.                          PHONE:         +34 949 336 806
Los Charcones, 17                         FAX:           +34 949 336 792
19170 El Casar - Guadalajara - Spain      WEB: http://www.hvsistemas.com


_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.