[time-nuts] Results parts selection + commercial assembly poll?

Tijd Dingen tijddingen at yahoo.com
Mon May 16 20:53:43 UTC 2011


Since the last few post on that "alternate list" were by me, and were never answered, my working assumption was much the same thing.
Apparently not enough interest. Oh well, slowly plow forward on my own then.

Which is a bit of a pity, since I am sure that with a few people (3 or so) this whole DIY counter business is going to be better and done quicker. But no interest is no interest.


regards,
Fred

PS: and yes that was a hint. Get to it already, you collective fence sitters. :P





________________________________
From: Bob Bownes <bownes at gmail.com>
To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
Cc: Tijd Dingen <tijddingen at yahoo.com>
Sent: Monday, May 16, 2011 5:56 PM
Subject: Re: [time-nuts] Results parts selection + commercial assembly poll?

I'll add that for some reason the discussion never morphed over to an
alternate list created just to discuss a counter project without
taking up bandwidth here. Not sure that there was enough interest.

Other Bob


On Mon, May 16, 2011 at 11:53 AM, Bob Camp <lists at rtty.us> wrote:
> Hi
>
> The polls ran for less than a day before they drew considerable fire for
> using too much bandwidth. Since we still had several steps to go (what to
> design, what to design it with, and who to design what), it was dropped.
> Doing a group general purpose FPGA based timing board isn't going to happen
> within the perceived bandwidth limits here.
>
> Bob
>
> -----Original Message-----
> From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
> Behalf Of Tijd Dingen
> Sent: Saturday, May 14, 2011 5:04 PM
> To: time-nuts at febo.com
> Subject: [time-nuts] Results parts selection + commercial assembly poll?
>
> Incidentally, did something ever come of these two polls? I was trying find
> the conclusion / results, but could not find it on the list. Entirely
> possible that I am blind for which I apologize in advance. Anyone know what
> came of it?
>
> regards,
> Fred
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>


More information about the Time-nuts_lists.febo.com mailing list