[time-nuts] FTS 1200
Bob Camp
lists at rtty.us
Thu Aug 9 23:58:28 UTC 2012
Hi
Best bet is a bad solder joint. Likely on the crystal it's self. Of course it could be on anything in series with the crystal.
Bob
On Aug 9, 2012, at 7:49 PM, EWKehren at aol.com wrote:
> The unit starts high and over 20 minutes comes down to 4.9999975 with 0 V
> on the EFC. Any voltage on pin 2 and it quits oscillating.
> Bert
>
>
> In a message dated 8/9/2012 7:06:48 P.M. Eastern Daylight Time,
> lists at rtty.us writes:
>
> Hi
>
> As the unit warms up, you should be able to tell weaner it starts off
> above 5 or below 5 MHz. There are enough different crystal cuts that *might* be
> in there that checking it at turn on is the easy approach. If it starts
> low and is off low, the heater may be the issue.
>
> Bob
>
> On Aug 9, 2012, at 6:53 PM, EWKehren at aol.com wrote:
>
>> Bjoern
>> No not able to tune it to 5 MHz.
>> Bert
>>
>>
>> In a message dated 8/9/2012 6:48:59 P.M. Eastern Daylight Time,
>> bg at lysator.liu.se writes:
>>
>> Hi Bert,
>>
>>> I have a FTS 1200 that is off by about 2 Hz. Have decided to take a
>>> closer look. Does any one have technical Information I should study
>>> before I
>>> open it up.
>>> Thanks
>>> Bert Kehren
>>
>> The efc range on my FTS 1200 goes from about -1.5Hz to +2Hz (0V to
> +10V).
>> Is your FTS1200 of even with max (or min) efc voltage?
>>
>> --
>>
>> Björn
>>
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list