[time-nuts] FE-5680A programming connector pinout

paul swed paulswedb at gmail.com
Thu Feb 2 04:17:11 UTC 2012


Nice pix
Thanks

On Wed, Feb 1, 2012 at 8:50 PM, Elio Corbolante <eliocor at gmail.com> wrote:

> The 15 pin connector (near crystal oscillator) is used for JTAG programming
> the XC8572XL (XC) and the PSD813F1V (PSD).
> According to my analysis the pinout is the following:
>
> 1) Vcc/+5V - goes to pin 5 of MAX882 voltage regulator: its 3.3V output
> powers XC and PSD
> 2) Ground (GND)
> 3) PSD pin PC6 (JTAG-TDO)
> 4) PSD pin PC5 (JTAG-TDI)
> 5) PSD pin PC4 (JTAG-/TERR) [on datasheet erroneously shown connected to
> Vcc]
> 6) PSD pin PC3 (JTAG-/TSTAT)
> 7) PSD pin PC1 (JTAG-TCK)
> 8) PSD pin PC0 (JTAG-TMS)
> 9) no known connection
> 10) no known connection
> 11) XC pin 30 (JTAG-TCK)
> 12) XC pin 28 (JTAG-TDI)
> 13) XC pin 53 (JTAG-TDO)
> 14) XC pin 29 (JTAG-TMS)
> 15) no known connection
>
> I think the +5V on pin 1 should be enough to program the two chips without
> requiring any power on the DB9 connector.
>
> My MQP Pin-Master 48 programmer SHOULD be able (via JTAG) to read the
> FLASH/EEPROM contents of the PSD813F1V: during the weekend I will try to
> dump the firmware of the FE-5680A.
> If the PSD chip is JTAG read protected I will have to desolder it and try
> to read its contents directly accessing Address/Data lines.
>
> at the following address you will find a (rather big) annotated picture
> regarding the connector pinout:
> <http://www.rhodiatoce.com/pics/time-nuts/FE-5680A_annotated.jpg>
> http://www.rhodiatoce.com/pics/time-nuts/FE-5680A_annotated.jpg
>
> _       Elio Corbolante.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>



More information about the Time-nuts_lists.febo.com mailing list