[time-nuts] Low-Cost Rubidium Performance

[Magnus Danielson]

Hi Bob,

On 02/09/2012 11:04 PM, Bob Camp wrote:
> Hi
>
> You might check how well buffered the 60 MHz is before you tap into it. It
> may need a bit buffering.

The U.FL. connector is very uncommon on JFET probes, so I assume it can 
drive a 50 Ohm load. Otherwise I would agree with you. An open ended 
termination would be possible, but I will be almost a wavelength away 
very quickly anyway as a wavelength is only about 3,3 m of coax.

Cheers,
Magnus