[time-nuts] EF-5680A Breakout board

[Attila Kinali]

On Fri, 13 Jan 2012 00:20:08 +0000
"gonzo ." <cadbloke at hotmail.com> wrote:

> your most welcome to the original CAD files (you can then do any mods that suit your purpose).
> The design was done using the free version of Eagle, so anyone can have a go.

If you could send them to me, i would very much appreciate it.
 
> As for making it cheaper, your welcome to try.
> I hope I'm covering my costs, but I'm certainly not making a profit.

I doubt i can produce them much cheaper than you. Unless you production
is done in a low-wage country, the costs are +/-20% the same.
What i'd aim to reduce is the shipping costs, which is quite substantial
if you are shipping something from australia to europe.

			Attila Kinali

-- 
The trouble with you, Shev, is you don't say anything until you've saved
up a whole truckload of damned heavy brick arguments and then you dump
them all out and never look at the bleeding body mangled beneath the heap
		-- Tirin, The Dispossessed, U. Le Guin