[time-nuts] Progress on the FE-5680A serial commands!
EWKehren at aol.com
EWKehren at aol.com
Fri Jan 20 11:31:04 UTC 2012
Maybe there is a way to vary the C field through a digital command, in
one of their specifications I noticed a spec that stated that the frequency
can be set in 1 E-13 steps. Is there a DAC on the board?
Bert Kehren
In a message dated 1/20/2012 12:52:48 A.M. Eastern Standard Time,
newell+timenuts at n5tnl.com writes:
Here's some data from one of my working FE-5680A units:
http://n5tnl.com/time/fe-5680a/graphs/fe5680_2_ch3.png
http://n5tnl.com/time/fe-5680a/graphs/fe5680_2_ch4.png
This assumes that the reply from the undoc command 0x5a is the raw
counts from the 4 channel 12 bit ADC. I think channel 3 is a temp
sensor. What would channel 4 be? Photodiode output?
Channels 1 and 2 are pretty much a straight line. I think Pete
figured out channel 1 was connected to a trim pot, right? Channel 2
sits at 2100 counts or so from power up 'till down, so I'm guessing a
supply rail.
Running graphs now for the problem child. Hopefully this weekend
I'll be able to run two Rbs at the same time and see about tweaking
the freq on the bad one.
--
newell N5TNL
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list