[time-nuts] Trimble SMT board

David J Taylor david-taylor at blueyonder.co.uk
Tue Jun 26 05:32:02 UTC 2012


Hi David,

I have chked vith TAC32 SW, 9600 Baud  and Motorola binary code and  it is 
working OK.  .... even will initialize the SMT gps board when there is a 
power interruption and no any protocol comes out.
Also chked with the  Winoncore  SW and it display data but not all.. and 
this SW does not initialize the SMT board.

Of course and Trimble gps Studio is OK.

Hope this helps a little.

Rgds Ernie.

____________________________________

Thanks for that, Ernie.  Would I be right in thinking that these evaluation 
boards have no on-board battery backup, so each time it's switched on it 
would revert to the as-supplied configuration, or is there some flash memory 
inside the Trimble SMT itself?

I don't have the TAC32 software.  I have a copy of TrimbleStudio, but have 
never installed it.  I've just found TBoltMon and downloaded it, and 
WinOnCore 12.

Thanks,
David
-- 
SatSignal Software - Quality software written to your requirements
Web: http://www.satsignal.eu
Email: david-taylor at blueyonder.co.uk 





More information about the Time-nuts_lists.febo.com mailing list