[time-nuts] Encoded 1PPS signals
Bob Camp
lists at rtty.us
Tue Jun 26 16:12:45 UTC 2012
Hi
I suspect that encoding 10 bits via AM PWM is likely to be a bit exciting
from a signal to noise standpoint on the receiving end. Back in the good old
days a 1/3 2/3 width switch was a normal way to encode a single bit.
Bob
-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Clayton G
Sent: Tuesday, June 26, 2012 9:16 AM
To: Discussion of precise time and frequency measurement
Subject: [time-nuts] Encoded 1PPS signals
Hi Nuts,
I have been building an LF transmitter, and have provision for a 1PPS input
for calibration purposes. However I would like to be able to provide more
time information than just the second pulses. It occurs to me that full time
info could be encoded onto a 1PPS stream by changing the width of the pulse
itself. The rising edge can be left unchanged to indicate the precise
second, but the trailing edge can vary between (say) 100mSec and 300mSec,
and this could encode 60 bits (with suitable idle pulses etc for
synchronisation) in each minute. Using this I could encode full date and
time into the 1PPS stream.
My question is, does such a standard already exist, or has anyone developed
something along this line?
If no, I plan to implement something suitable myself, and will publish it
should it be useful to others.
Regards
Clayton
(VK1TKA)
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list