[time-nuts] Cisco ADP-30RB Power Supply Use with TBolt
Chris Albertson
albertson.chris at gmail.com
Sat Mar 17 02:49:02 UTC 2012
On Fri, Mar 16, 2012 at 7:30 PM, Sam Reaves <sam.reaves at gmail.com> wrote:
> Hello all,
>
> I have a couple of these supplies that I plan to use with the TBolt. From
> what I can gather
>
> from searches on the internet the RO pin between the two grounds on the
> power connector is a remote turn on
> which is enabled by grounding this pin.
>
I cut the connector off mine. So I don't know the location of the pins.
I was kind of afraid to simply ground a power supply lead so I used a low
value resistor. You might try that so as to prevent damage if you guess
wrong about which wire to ground. 100R or 50R are good values to use
>
> Chris Albertson
Redondo Beach, California
More information about the Time-nuts_lists.febo.com
mailing list